From: peggyunderpressure.com
INGREDIENTS:
– 2 Cups Beef Broth
– 1 Cup BBQ Sauce (Your brand of choice)
– 1/2 Cup BBQ Sauce; this is for after the cooking
– 3lbs. Beef Brisket or Chuck Roast
Pour the cups of beef broth into the main cooking pot of the
pressure cooker. Place the brisket or
chuck roast into the broth and then top the meat with 1 cup of BBQ sauce. Coat it thoroughly all over. Lock and load the pressure cooker lid and
program it to cook for 60-minutes.
Tada, that’s it!
That’s all the direction you have to give your hubbie to get dinner
rolling. Easy peezy.
(When I was cooking my brisket, my pressure cooker wouldn’t
pressurize. It would heat up for
5-minutes and then beep and cycle over to keep warm. This usually happens when the machine is
sensing not enough liquid and too much heat is present so it will auto
shut-off. Well, I had plenty of liquid
and I wondered why it was doing that. I
realized it was because the meat was one large slab of beef that basically
covered almost the entire bottom of the pot.
Not enough liquid was actually touching the base. So what I ended up doing was cutting up some
potatoes that I had to use up anyway and placed it under the beef to raise it
off the bottom of the pot by a bit. That
way, it created pockets for the liquid to flow under. If you don’t have potatoes, you can always
just use a trivet too.)
Once the cooking cycle is complete, release the pressure and
unlock the lid. The meat should be
falling apart into smaller portions.
Remove each portion to a platter.
Use a couple of forks and shred the meat into small shredded pieces. When all the meat has been shredded, ladle
about 1 cup of the cooking liquid into the beef and mix. Then add the other 1/2 cup of BBQ sauce and
mix as well.
This is where I got an inspiration. The BBQ sauce I used just didn’t have enough
kick to it. So of course, I pulled out
my trusty jar of Habanero Pepper Jelly!
Hey, why not! I added about 2
tbsp to the shredded beef and gave it a good mix again.
No comments:
Post a Comment